Spinning Switch Storage

Spinning Switch Storage by ForgeCore

Printed On Ender 3 V3 SE Using Filament eSun PLA+

Printed without Supports, Printed without Rafts, Infill 20 %

This spinning switch storage container is super fun, practical, and can now also be used as a travel case. This version has an included lid that can store into the base, so it's out of the way when you don't need it, but is right there to use as the lid when you're traveling.

1. The Magnets: Small Round Magnets (same magnets as all other prints)

You'll need 22 magnets per spinner

2. Bearings: Fidget Spinner Bearings

You need just 1 bearing per spinner

Get 30% off your first three months when you signup to forgecore on thangs using code “Kady30”


Highlighted models from ForgeCore